English
中文
Spanish
French
Arabic
Korean
German
Russian
English
column information in the field of hydraulic machinery, relying on friends [20 years] industry deep plowing experience, focus on the output of hydraulic technology innovation, market trends, application cases and other high value content. With the aim of "professional, timely and deep", we provide one-stop information service for engineers, purchasing decision makers and industry researchers, helping users to accurately grasp the pulse of hydraulic technology development.
1. Check the exterior of the 315 ton hydraulic press as a whole. 2. Check the clutch device. 3. Run the machine. Check whether the conveyor chain is worn, and check whether the tension is appropriate. If there is any problem, replace or repair it. here the main check clutch...
Read More
The reason why the power of the 200-ton single-arm hydraulic press is blocked: the most likely reason is that the plunger head of the single-arm hydraulic press is broken or the bearing in the pump falls off the pump. although the plunger head is made of metal, it breaks under the huge pressure in the pump of the single-arm hydraulic press...
Read More
The hydraulic cylinder of the general hydraulic press is suitable for working in the range of -10- 80 ℃, as far as possible not higher than the limit of -20- 105 ℃. because most of the use of hydraulic cylinder ding preserved rubber seals, its working temperature of course can not be greater than ding preserved rubber work...
Read More
1. Keep the hydraulic oil clean before use. Hydraulic oil in the transport and storage process will be contaminated by the outside world, the newly bought hydraulic oil looks very clean, in fact, very dirty, must be put a few days later, after filtering into the hydraulic system. Two...
Read More
The leakage of the hydraulic pump of the 500-ton hydraulic press refers to the leakage of the hydraulic oil. In the work project, almost all hydraulic pumps will have similar problems. Its appearance will not immediately stop the operation of mechanical equipment, but it will reduce the capacity of the hydraulic pump of the hydraulic press...
Read More
Reasons for Excessive Downward Pressure of 1. 1. Excessive Support Pressure of 500 Ton Hydraulic Press; 2. The sealing ring of the hydraulic cylinder leaks oil. 3. The preset pressure of the pilot valve is too small; 4. Poor sealing of the cartridge valve port; 5. There is air in the oil circuit of the pressure gauge;...
Read More
1. reduce energy consumption The traditional quantitative pump is changed into a variable pump by using a 500-ton hydraulic press frequency conversion cabinet, and the frequency conversion speed regulation method of high pressure and low pressure dual signal input is adopted to replace the previous proportional valve speed regulation method, which greatly reduces energy consumption. in meeting the process...
Read More
1. Check whether the stretching hydraulic oil pump, control valve and pressure gauge are normal and whether the oil temperature is within the allowable range; 2. Check whether the mold has cracks and whether the fastening screws are loose; 3. Turn on the power switch of the hydraulic machine and start the cooling circulation motor; 4,...
Read More
For hydraulic equipment with different working characteristics, the requirements for oil temperature are also different. In general, the working temperature of the oil is between 30-60 ℃. For the high pressure system or program control system of hydraulic equipment, in order to reduce leakage, in order to ensure...
Read More