数控立车在我们实际的应用中应用很广泛，在我们进行的应用中，数控立车系统调试需要注意些什么呢，小编带领大家了解下。
1) Determination of input voltage, frequency and phase sequence. The basic work first confirms whether the capacity of the transformer meets the power consumption of the control unit and the servo system, and then checks whether the voltage fluctuation is within the allowable range. For the power supply current of the speed control unit and the spindle control system of the component controlled by the transistor, it must be strictly checked. Phase sequence, otherwise the fuse will be blown.
2) Confirm the setting of various parameters of the numerical control system and whether the numerical control vertical lathe studio can be in a good state. The setting of parameters is a necessary condition. Even for the same machine tool and the same type of random bed, there are differences. After adjusting the machine tool parameters, the parameters should be copied in time for future use after the machine tool reaches a good working state.
3) CNC machine tool interface detection. The numerical control system of modern numerical control machine tools has self-diagnosis function. Various status signals of numerical control system and machine tool programmable controller can be displayed on the CRT screen of the display. Users can check the status of each interface and whether the connection is correct according to the instructions and equipment list provided by the manufacturer.
4) Special note is that if the introduction of imported equipment also need to pay attention to the connection of the power supply of the numerical control system. Because the voltage level of drinking too much must match the tap connection of different power transformers and servo transformers in our country, otherwise the system will not work normally.
Therefore, it is very important to debug according to these points in our application, which can enable us to better carry out the application of CNC vertical lathe.