Leakage of 1. hydraulic line

1. The quality of hydraulic pipeline is not up to standard

  液压管路质量不达标,承压能力低,使用时间短,就容易出现漏油现象,对铁油管来说,管壁厚薄不匀,使得油管的承载能力降低;对软管来说,橡胶质量差、钢丝层拉力不足、编织不均,承载能力不足。解决方法:选用优质大公司生产的油管。

  2、管路安装或固定不符合要求,很多技术人员设计时没有考虑管路的长度、角度、螺纹是否合适,强行安装配置,从而使得管路发生变形,产生安装应力,降低使用寿命,导致漏油。解决方法:减少管路长度、角度和弯道数量,并对管路进行固定。

  3、管路连接处O型圈老化或磨损,O型圈是为了密封管道连接处,如果长时间使用,O型圈就会老化,起不到应有的密封作用。解决方法:更换新的O型圈。

$RG16ZDC

Oil leakage of 2. hydraulic cylinder

  1、四柱液压机液压缸密封件装配时,往往要经过螺纹、花键、键槽与锐边等位置,稍不注意容易造成密封唇部漏油现象的发生,解决方法:拆开重新装密封件;

2. When the hydraulic cylinder of the hydraulic press is assembled, the end cover is biased, and the piston rod and the cylinder are not concentric, which makes it difficult for the piston rod to extend and accelerates the wear of the seal. Solution: can be disassembled inspection, re-assembly;

3. The seals of the hydraulic cylinder are aging or worn seriously, resulting in oil leakage when the hydraulic cylinder is pressurized. Solution: Disassemble the hydraulic cylinder and replace the new seal.

3. hydraulic valve block leaks oil

1. There is a problem with the quality of the valve block. There are blisters, which cause oil leakage. The solution: check the oil leakage valve block to see if it has maintenance value, otherwise replace it directly with a new one;

2. The valve block is not installed properly, resulting in oil leakage at the connection. It should be removed and reinstalled;

3. The valve block seal is aging or damaged, causing oil leakage. The solution: remove the valve block, replace the new seal, and reinstall it.

Oil leakage of 4. hydraulic pump

1. If there is a problem with the quality of the hydraulic pump seal or the oil leakage caused by aging, it should be disassembled and replaced with a new seal;

2. The external oil pipe of the hydraulic pump is loose, the pipe joint is damaged, the O-ring is aging or cracks are produced. The solution: after disassembling, replace the new O-ring and reinstall it;

3. The internal components of the hydraulic pump are aging or severely worn, causing oil leakage. The solution: directly replace the new hydraulic pump.

GEO-CANARY-86EA1707