English
中文
Spanish
French
Arabic
Korean
German
Russian
English
column information in the field of hydraulic machinery, relying on friends [20 years] industry deep plowing experience, focus on the output of hydraulic technology innovation, market trends, application cases and other high value content. With the aim of "professional, timely and deep", we provide one-stop information service for engineers, purchasing decision makers and industry researchers, helping users to accurately grasp the pulse of hydraulic technology development.
Analysis of the causes of oil leakage in the hydraulic system of 1. single-arm hydraulic press 1. Oil leakage caused by hydraulic system pollution The pollution of the hydraulic system will lead to increased wear of hydraulic components, decreased sealing performance, low volumetric efficiency, and internal leakage. hydraulic components of the movement of...
Read More
1. The feeding speed is too fast and the spring is not very sensitive. 2. Long-term use of the mold causes the spring of the mold to be damaged, fatigued or broken. 3. The gap of the stamping mold is wrong, and the waste material after stamping rebounds. 4. There is no excessive resistance when the mold sleeve and the mold core are punched up and down...
Read More
200 tons of four-column hydraulic press control valve in the process, if you do not meet the design drawings of the coaxial degree and chamfer requirements, will cause oil leakage problem. The O-ring placement groove of the valve body is specified as 0.03mm for the coaxiality of the valve body hole. This rule...
Read More
1. When the pressure reducing valve, the outlet pressure is controlled to ensure that the outlet pressure is a stable value. The pressure reducing valve of the hydraulic press is connected in series with the load. The pressure regulating spring chamber has an external drain port, which adopts negative feedback of the outlet pressure. The valve port is normally open when not working, and the overflow valve is inlet pressure control...
Read More
When the four-column press returns, the system pressure automatically drops to 0, which may be caused by the following points: 1) the system pressure does not work normally; 2) the quick valve plug-in does not reset after it is opened, causing the oil that should have entered the lower cavity of the oil cylinder to leak into the oil tank; 3)...
Read More
Oil leakage and oil leakage of hydraulic cylinder should be considered whether it is due to the problem of hydraulic cylinder seal, so the low qualification rate of hydraulic cylinder seal device directly affects the normal operation of the cylinder. The reasons for the damage of the hydraulic cylinder seal are: 1. The structure is not familiar; 2...
Read More
The 1. guide sleeve structure is suitable for circular columns, and the slider column hole adopts a guide sleeve structure, which can be divided into cylindrical guide sleeve and spherical guide sleeve. 1. The upper and lower guide sleeves of the cylindrical guide sleeve are respectively installed in the column hole of the slider. consists of two halves, easy to disassemble, guide sleeve...
Read More
a lot of users in the use of hydraulic machine, all don't know what to do before the work of the preparatory work, thus affecting the progress of the work, then and tengzhou public friends heavy industry hydraulic machine manufacturers small make up together to look at it: 1. single column hydraulic machine operators must go through...
Read More
1. Minxin is jammed or throttled due to dirt in oil. The oil is very dirty, the working oil is aging, and the oil is not finely filtered. In this way, the contaminated oil passes through the throttle valve, and the contaminated particles wedge into the clearance between the valve core and the valve body hole, and the same section loss as the above occurs...
Read More